Tent flooring options: from groundsheets to timber decks
The main tent flooring options are a zip-in PVC groundsheet, a welded PVC floor tray on framed tents, a raised timber deck, or a hard base such as concrete, usually finished with rugs. For glamping, the most reliable combination is a deck with the tent’s own groundsheet or floor tray on top: dry, level and easy to clean. Groundsheets straight on prepared ground suit seasonal and event use; concrete is level and permanent but cold and prone to condensation unless it is insulated.
6 min read · Updated

What a tent floor has to do
A tent floor does more work than a floor in a building. It is the barrier against ground water and rising damp, the seal that keeps out insects, snakes and draughts, and the surface that takes a bed frame, a suitcase on wheels and a housekeeper’s mop every day. In cold weather it is also where most of the heat goes. And it has to meet the walls without a gap, because the join between floor and wall is where water and wildlife get in.
No single material does all of that perfectly, which is why most good installations combine two layers: a structural base underneath and a sealed, cleanable surface on top.
Tent flooring options compared
Most glamping sites end up with the fourth option: a deck with the groundsheet or floor tray on top.
| Floor | Best for | Strengths | Drawbacks |
|---|---|---|---|
| Zip-in PVC groundsheet on prepared ground | Bell tents, seasonal sites, events | Low cost; removable; seals floor to wall | Follows the ground; cold and damp on poor soil |
| Welded PVC floor tray | Swiss cottage, safari and frame tents | Upstand at the walls; wipe-clean; waterproof | Needs a level base; point loads can wear it |
| Raised timber deck alone | Verandas and open pavilions | Dry, level, warm underfoot; looks premium | Gaps let in draughts and insects inside a tent |
| Deck with groundsheet or floor tray on top | Most glamping keys | Combines a dry base with a sealed floor | Highest cost; deck needs building locally |
| Concrete slab | Permanent dining tents, stores | Level, hard-wearing, takes heavy loads | Cold; condensation under covers; permanent |
| Interlocking or modular floor panels | Event structures on hard standing | Fast to lay and lift; level over minor bumps | Hire-grade look; joints collect dirt |
Tent groundsheets: zip-in, sewn-in and footprints
Our bell tents use a zip-in PVC groundsheet: 540 gsm on the 4 m and 5 m, 610 gsm on the 6 m. Zipping it in means the walls can be rolled up on hot days without lifting the floor, the sheet can be taken out to clean and dry, and a worn groundsheet can be replaced without replacing the tent. Sewn-in floors are simpler but make all of that harder.
Under the groundsheet, a separate footprint takes the abrasion, punctures and ground damp so the tent floor does not. The Tent Groundsheet 5M and the Tent Groundsheet 4M are cut fractionally inside the tent line, so rain running off the wall lands on the ground instead of on the sheet, where it would flow underneath the tent. A footprint larger than the tent catches that water and sends it under the floor.
Prepare the ground first: level it, remove stones and roots, and on stony ground lay a sand bed. A Ground Sheet Tarpaulin is a cheap sacrificial layer for a season on rough ground.
PVC floor trays on framed tents
Framed tents such as the Swiss Cottage 10 × 20 use a welded PVC floor tray: a single sheet with an upstand of a few centimetres around the edge, joined to the bottom of the walls. Water on the deck outside cannot cross the upstand, and the whole floor can be mopped like a hotel bathroom. Our staff and military frame tents use the same detail.
A floor tray must sit on a level, smooth base. Screw heads, splinters and gaps between deck boards wear through it from below; protect it with a layer of hardboard, felt or a dense underlay where the deck is rough. From above, spread furniture loads with pads, and keep stiletto heels and dragged luggage to the rugs.
Timber floors and decks inside a tent
A raised timber deck is the best base most glamping tents can have, and we cover it fully in platforms and decks for glamping tents. Inside the tent, the deck should be covered by the groundsheet or tray, because open board gaps bring in draughts, dust and insects.
For flagship keys, some operators lay a finished interior floor of tongue-and-groove boards over a membrane on the deck, inside the wall line, then bring the canvas down outside it. It looks and feels like a room, but it must be detailed carefully so water from the walls drains away from the floor edge and the timber can breathe.
Pitching a tent on concrete or a hard base
A slab is level, permanent and takes almost any load, which is why it suits dining structures, stores and storage shelters. For sleeping tents it has two problems. It is cold, drawing heat out of the room all night, and warm, moist air from inside condenses on the cool slab under any covering, leaving the underside of the groundsheet or rug wet by morning.
If you must use concrete, lay an insulating underlay and a damp-proof layer before the groundsheet, give the slab a slight fall to its edges, and finish it fractionally inside the tent wall line for the same reason as a footprint. Bear in mind that planning authorities often see a slab as permanent development where a tent on a deck is not.
Rugs and floor insulation for hot and cold sites
Treat rugs as part of the floor specification. In cold sites, a closed-cell foam underlay beneath the groundsheet or tray and wool rugs on top make a measurable difference to comfort; see how to insulate a canvas tent for winter. In humid heat, choose thinner rugs that dry quickly, lift them weekly to air the floor, and keep the deck well ventilated underneath.
Groundsheets and trays are wear parts. Plan on replacing them before the canvas, and read replacement tent parts for what to keep in stock. If you are not sure which floor suits your site, send us the ground conditions and tent type and we will recommend a build-up.
Questions buyers ask
What is the best flooring for a bell tent on grass?
The tent’s zip-in PVC groundsheet over a footprint cut just inside the wall line, on levelled ground. Add rugs inside for comfort.
Should a footprint be bigger than the tent?
No. It should be slightly smaller than the tent’s footprint, otherwise rain running off the walls collects on it and flows under the floor.
Can I pitch a glamping tent on concrete?
Yes, but insulate it and lay a damp-proof layer first, or condensation will form under the floor. A concrete slab may also count as permanent development for planning purposes.
Can I put carpet in a tent?
Rugs are better than fitted carpet because they can be lifted, aired and dried. Fitted carpet holds moisture against the floor and is hard to clean in place.
How long does a PVC tent floor last?
It depends on traffic, sun exposure and the base under it. Treat groundsheets and floor trays as replaceable parts and expect them to wear out before a well-kept canvas.